Fiat Abarth OTR 1000 coupe

grt · May 01, 2005, 07:29:25 AM

I have recently purchased a Fiat Abarth OTR 1000 coupe and would like to hear from any other owners

naegeli · May 02, 2005, 05:21:31 PM

hello grt,

i am peter in switzerland and this is my 1000 otr...

ciao

guy moerenhout · May 03, 2005, 10:13:58 AM

there was in holland ex van tienhoven I work on this car and was sold to G.B. white ,nice original car.One engine is also in Abarth castle in france chez M.Pont

naegeli · May 30, 2005, 09:54:28 AM

hello graeme,
here are the pics that should help you put your car together...

best regards

peter

trevor · June 01, 2005, 08:55:09 PM

Hello Peter (naegeli), the photos are quite informative. I am fabricating a grille / radiator for front of an 850 coupe. If you have a close up of your grille / radiator from front and from inside of car trunk, it would be most helpful. Many thanks Trevor

naegeli · June 03, 2005, 07:17:23 PM

hello trevor, i will do this tomorrow....

here are some photos for graeme, i hope this helps...

best regards

trevor · June 03, 2005, 09:25:30 PM

Hello Peter, Thanks for the assistance. Pictures really are informative. Regards Trevor

naegeli · June 05, 2005, 01:55:04 PM

ok , here are the pics of the front grille...and more for the oil circuit.

ciao...

trevor · June 05, 2005, 07:53:51 PM

Hello Peter, Many thanks for the grille photos, they give me exactly the detail I was after- now for some careful fabrication work. Most helpful. Thanks again. Trevor

grt · June 06, 2005, 02:38:44 PM

Peter

Thanks very much for the photos, they are a great help. I look forward to the latest ones being properly sized. I tried to post some photos of the radiator for Trevor but it obviously didn't work out. I'll try again.

Thanks again

Graeme

grt · June 06, 2005, 02:44:12 PM

Some more pictures

grt · June 06, 2005, 02:57:38 PM

Peter

Another question. Please see the picture.

Thanks

Graeme

trevor · June 06, 2005, 08:39:28 PM

Graeme, Thanks for the radiator and shroud photos, most helpful with the detail shown. Regards Trevor

naegeli · June 07, 2005, 08:37:01 AM

hello graeme,

i have your pics but cannot upload for the mment, any way the two hoses run from the crankcase and valve cover back and then along the fueltank (above) to the other side into a small black plastic recipient that is fixed on the right engine bay wall...

i will try to upload the pix later.

ciao

peter

naegeli · August 22, 2005, 09:59:01 AM

trebor, for uploading pictures, just click additinal oprions and attached a picture that you define by browsing

look here: abarth squadra storica forum | abarth cars | fiat abarth 1600, 2200 and 2400 | Topic: 2300 S